The ASI dynamic mixer uses the same principal as our static mixers, except additional energy is added to the flow stream by a magnetically coupled rotor. This results in far greater mixing for the same amount of mixer dead volume, but also results in more flush-out volume and tailing than static mixers. Dynamic mixers work best in steady state flow conditions when multiple solvents need to be mixed. TFA presents another application there the ASI dynamic mixer performs well. A photo shows 1 mL Binary model also 3D images show Binary models. The 3 inlet posts for Ternary are located 120° apart.
Approximately up to 20 Cp viscosity can be mixed.
The upper half of the mixing chamber, which contains the rotor, can be removed and cleaned. The lower half contains the ports and can be accessed but for cleaning.
Ternary Dynamic Mixer Assembly
- Specifications:
Maximum Operating Pressure: 4,000 PSI
Delay volume: 150 µL, 250 µL, 350 µL, 500 µL, 650 µL, 1 mL
Back pressure: < 1 Bar @ 1 mL/min. with water
Operating Temperature: 0 - 40°C
Power requirement: 100 - 120 Vac/200 - 240 Vac, 50 - 60 Hz
Inlet & Outlet Ports: 1/16 CPI 10-32
Power cord length: 80"
Enclosure Box Dimensions: 3.5" W x 4.5" D x 2.3" H
Total Height: 150 µL: 3.5", 250 µL/350 µL: 4.5", 500 µL/650 µL: 5.1", 1 mL: 4.3"
- Part Number:
- 463-0150A
- Wetted Material:
- 316 Stainless Steel, PEEK